Radio Control 3D Electric Airplane Foam kit

Enjoy the sport of flying a 3D electric airplane.

The 3D Mavrick can fly all of the maneuvers the large planes fly.

This kit was designed to fly in winds up to 10mph.

These kits are CNC cut out of foam with interlocking parts.
This makes assemble easy. The foam is light and strong.
You can paint with acrylic paints.

Read customers comments on our kits.

http://www.rc-products.net/mavrick-comments.asp

Depron foam 6mm thick

      Wing Span                     26"
     Length                           29.5"
      Flying Weight/battery          14.2 oz.
      Wing Area                     416sq “

Mavrick Bipe parts:

Hardware:

(2) 3/16” carbon fiber tube

1/16” light ply 2”sq. (motor mount)

park flyers control horns.

control wire 3/32” x 10” (rudder & elevator)

control wire 3/32” x 10” (aileron)

Recommended Equipment:
Motor:                  AXI 2208/34 or AXI 2212/34
Controller:           Jeti Advance 18 Amp Blushless
Prop:                    APC 10/4.5
Radio Receiver:   6 ch. w 4 HS-55 Servo Hitec

Battery: Li-Po 1000 mAh, 3 cells (11.1V)

PDF Drawing files

Print the files use the best setting to get the full page print.

Tape the pages together and cut out the parts.

Place the paper parts on the foam you want to use.

Cut the parts out and then use the assy. Manuel

You can find on the web site.

http://www.rc-products.net/support.asp